DXP_CS1_QE2 / DXP_CS1_QE3 / DXP_CS1_QP1
This is a sensor device that can add hand tracking functionality to Meta Quest2/3/Pro controllers. It is possible to achieve hand tracking equivalent to or better than the Valve Index controller.
*To avoid misunderstandings regarding product specifications, please read the entire explanation below before purchasing.
*This product is a pre-order item. Please refer to the explanation below for shipping time.
*Please note that it is not possible to change order details (change of straps) after May 6, 2024.
Contents
- Knuckle strap for Quest2 or 3 or Pro controller (for both hands)
- ContactSheet (for both hands)
- Communication dongle (1 piece)
- Type-C USB cable (2 pieces)
- Silicone band for fixation
- replacement tape
- Simple instructions
- Warranty
*You can choose between attaching with a silicone band or attaching with double-sided tape.
*Operation with anything other than the included strap is not guaranteed.
*Sheet itself is compatible with Quest2, 3, and Pro. The only difference is the contents of the strap.
how to use
- Attach the knuckle strap to the controller.
- Attach ContactSheet to the controller.
- Install DivingStation on your PC.
- If you are using it in Index emulation mode, the setup is now complete.
- Separate avatar setup is required when using in OSC mode.
Please check the documentation for details.
| battery capacity |
900mAh |
| Continuous operation time |
Approximately 10 hours (built-in battery) |
| charging time |
Approximately 2 hours (when power is OFF) |
| Charging method |
USB Type-C terminal |
| hand tracking |
bend each finger
*When using OSC parameters, it is possible to obtain the independent movement of each joint.
*Independent movement of the first joint (the joint closest to the fingertip) cannot be obtained. (Pose with nails raised, etc.)
*Independent movements of the 2nd and 3rd joints can be obtained.
*In the case of index emulation mode, independent movements of joints cannot be obtained.
|
| Wireless communication |
Unique communication using 2.4GHz band (dedicated dongle)
|
| Onboard sensor |
Multipolar capacitive sensor, pressure sensor
*Due to the principle of the sensor, the frequency of calibration may increase if the amount of sweat in the palm of the hand is large. Please understand in advance.
|
| Compatible streaming software |
VirtualDesktop*, AirLink*, QuestLink*
SteamLink*
*No avatar setup required (index controller emulation)
|
| Compatible applications |
When using VirtualDesktop/AirLink/QuestLink/SteamLink
VRChat, Resonite, Cluster, VirtualMotionCapture, and other SteamVR applications (using Index controller emulation or OSC)
*Operation is not guaranteed with all software.
standalone mode
Although connection between the PC and HMD is not required, DivingStation must be started on a PC connected to the same network as the HMD. (OSC required)
*When using in standalone mode, the PC does not need to be a high-end model for gaming. If it has general processing performance and can run DivingStation, there is no problem.
|
| OSC parameters |
Full version 177bit
Lite version 107bit
*Avatar setup is automated.
*The number of consumption parameters is a guideline. This may change in future development.
Please check this out for details.
|
About warranty
The warranty is valid for one year after the product is shipped.
We will repair or replace any defects caused by our design or manufacturing, or any other defects that are thought to have occurred due to our negligence, free of charge. As specified in the warranty terms, we may charge repair costs for defects or damage that are considered to be caused by user negligence.
